AR-15 Pistol Grip (X2 Recoil Reducing) – Flat Dark Earth
If you’re building an FDE rifle and still running a basic grip, you’re leaving comfort on the table. This X2 recoil reducing grip is designed to cushion some of the snap and give you a more consistent, controlled hand position—especially when you’re running the gun fast. Made by ATI Outdoors.
Fitment
Fits most AR-15 and AR-10 style rifles that use the standard AR pistol grip mounting interface.
Does NOT fit
Will not fit if your rifle uses a locking ring/castle nut setup with extra sling loops or QD mounts that interfere at the rear of the grip area.
Not for platforms that don’t use the standard AR grip mounting pattern.
Tools needed
Screwdriver or hex/Allen key (depends on your grip screw)
Small punch helps control the safety detent and spring
Install notes
Remove your old grip carefully so the safety selector detent spring doesn’t launch.
Install the new grip using your original mounting hardware. Tighten snug, then function check the safety for positive clicks
Any required warnings/notes
Assumption to avoid returns: this uses the standard AR grip screw and detent/spring layout. If your lower is proprietary, verify it takes standard AR grips before ordering.
