Gun Storage Magnet – Pac-Mag – 3 Magnet – Black
PLEASE DOUBLE CHECK DETAILS AND FITMENT BEFORE PURCHASE.
The Lyman Pac-Mag Gun Storage Magnet is a compact firearm storage accessory built to hold handguns, rifles, or shotguns on a mounted surface for quick access and cleaner organization. It uses a 3-magnet design with an overmolded rubber contact surface to help protect finish while giving more holding power than the usual one-magnet cheapo setup.
This is meant for storage and staging, not magic. It is useful under a desk, inside a cabinet, by a nightstand, in a safe, or on a wall or vertical surface where fast access and clean organization matter. The included screws, drywall anchors, and double-sided adhesive tape give you a few mounting paths depending on the surface and use case.
Fitment
- Built to hold handguns, rifles, and shotguns.
- Rated for up to 30 pounds.
- Works on horizontal or vertical mounting surfaces when installed correctly.
Does NOT fit
- Not a child-safety device.
- Not a locking storage solution.
- Do not treat adhesive-only mounting as the answer for every firearm weight and surface type without verifying the setup.
What it does
This magnet holds a firearm against a mounted surface so you can stage it where you want it instead of letting it rattle around loose. It is a storage and access tool meant to keep a firearm accessible and organized while protecting contact points with an overmolded rubber surface.
Why it’s worth it
It is simple, useful, and stronger than the flimsy single-magnet stuff that loves to make promises and then drop a pistol when mounted vertically. The 3-magnet design and 30-pound rating are the whole selling point here. Good accessory for safes, workspaces, nightstands, or vehicle-adjacent storage setups where lawful and responsible use applies.
Specs
- Product type: gun storage magnet
- Color: black
- Magnet design: 3 magnets
- Rated capacity: up to 30 lb
- Protective surface: overmolded rubber
- Mounting hardware included: yes
What’s included
- Pac-Mag gun storage magnet
- Mounting screws
- Drywall anchors
- Double-sided adhesive tape
Install notes
Mount to a solid surface that matches the firearm weight and intended orientation. Screwed installation is the smarter route for heavier firearms or higher-risk placement. After installation, test the exact firearm and position before trusting it with anything important.
Verify before you buy
Verify your mounting surface, firearm weight, and intended orientation before purchase. This is a quick-access storage accessory, not a locked safe and not a substitute for responsible storage practices around unauthorized users.
